Legal notice

Terms of Service & Legal Notice

By visiting our site and/or purchasing products from Tone Depot, you engage in our "Service" and agree to be bound by the following terms and conditions, including all additional policies referenced herein.

1. Governing Law

These Terms of Service and any separate agreements whereby we provide you Services shall be governed by, interpreted, and construed in accordance with the laws of the State of Queensland (QLD), Australia, and the Commonwealth of Australia, without regard to conflict of law principles.

2. Technical Specifications & Brand Clarification

We endeavor to present accurate product descriptions, cable capacitance specs, DC voltage/mA ratings, and pricing. Independent Audio Hardware Brand Notice: Tone Depot is an independent designer and retailer of pro-audio cables, isolated power supplies, and studio hardware. Tone Depot is not affiliated with, sponsored by, or endorsed by Mogami, Neutrik, Voodoo Lab, Strymon, Cioks, Pedaltrain, Boss, or Fender. Any comparative references are made strictly for standard connector sizing (1/4" TS/TRS, 3-pin XLR, 2.1mm x 5.5mm DC barrel), center-negative polarity conventions, and consumer guidance. Tone Depot reserves the right to correct any inadvertent inaccuracies at any time without prior notice.

3. Pedalboard Voltage Polarity Mandate, Mains Power & Acoustic Foam Safety Warning

CRITICAL DC VOLTAGE & POLARITY PROTECTION WARNING: Before connecting any guitar pedal or studio processor to an isolated power supply output, ALWAYS verify the pedal's required voltage (9V, 12V, or 18V DC), minimum current draw (mA), and barrel polarity (standard 2.1mm center-negative vs center-positive). Connecting a 9V pedal to an 18V output or reversing polarity without the proper polarity-reversal adapter will permanently destroy internal pedal circuitry. Mains Electrical & Cable Care: Operate AC-to-DC power supplies exclusively with the supplied 240V Australian SAA-approved IEC mains cord connected to a properly earthed wall outlet, and keep cooling vents unobstructed. Never yank audio cables by the wire when unplugging—always grip the solid metal connector barrel, and coil cables using the over-under method to preserve internal copper shielding. Tone Depot is not liable for damaged pedals caused by selecting incorrect 12V/18V voltage rails or reversed polarity cables, or internal wire breaks caused by yanking cords.